For off season storage and maintanance of fully charged batteries in boats, PWC, snowmobiles, ATV's etc. Keeps your batteries factory fresh without overcharging of boiling electrolyte. It supplies only the maintenance charge necessary to preserve battery life. Maintains 12V flooded or gel cell batteries rated between 5 and 125 amp hours.Input voltage: 100-130V AC/60Hz. One year warranty
Price:$ 37.95 / Each | |
| |
World's smallest 3-Amp 12-Volt Charger, for 12-volt systems. Can also be used as a full-time maintenance charger. Comes complete with 6' AC cord and 4' DC output with alligator clips. Fully potted, waterproof and vibration resistant.
Price:$ 89.95 / Each | |
|
Fully automatic 3-stage charging for fast, full charging and safe maintenance charging. Independant dual outputs for use with two 12 volt batteries and a common ground. For permanent mounting and hardware applications. LED ready indicators. Small and lightweight. A full 10 amp charge at 12vDC. Components are fully sealed in durable, corrosionproof, waterproof thermal compound. Electronic overload protection. Manufactured to survive harsh marine conditions.
For group 24 and group 27 batteries.
Specifications:
10 amps, 2 banks, 2 7/16"D x 7 3/4"W x 5 1/8"W
Price:$ 129.95 / Each | |
| |
| A trolling motor charger for the boater who needs 10-12 hour full recovery, ideal for systems with two 12 volt batteries or a 24-volt configuration. Comes prewired with a 6-ft. AC cord and two 4-ft. DC outputs.
2 banks, 12 volt 10 amp
Price:$ 119.95 / Each | |
|
Features "smart leg" technology, which provides individual charging attention to each battery and eliminates potential for over charging. The benefit is a well designed charging system that protects your battery
investment. Cruising chargers also function as a continuous 12V power supply to run your DC accessories while at the dock. Encased in a fully sealed, ignition protected package that is impervious to moisture, vibration and caustic battery gases.
Price:$ 239.95 / Each |  |
| |
| System provides constant power allowing use of items such as aerator, spreader lights, radio, etc. while charging. Input voltage 100-130AC/50-60Hz. Pre-wired with 2-6' cables for 12V DC output and one 120V AC input cable with 15 amp plug. Internal ground provides boat protection without the need of an AC electrical panel.
Charger's electronics are protected against impact, vibration, overload and reverse polarity. Lifetime warranty against water damage.
Price:$ 339.95 / Each | |
|
Use to charge and/or maintain 12v batteries. Waterproof, shockproof and corrosion proof. Features 6' AC cord and 4' DC output wire with alligator clips, LED indicators and overload protection.
Input voltage 100-130V AC 50-60Hz.
Two year warranty
Available in 6 amp or 10 amp models.
Model 2606A: 6 amp version: 5" x 3 1/2" x 2 1/4"
Model 2612A: 10 amp version: 5" x 5" x 2 1/4"
Price:$ 79.95 / Each | |
| |
| Tournament fishermen with 4 batteries for 12V/24V/36V systems plus cranking/house battery. Features three 10 amp chargers plus one 5 amp charger all in one housing. Will supply quick recharge power to a trolling battery system plus provide maintenance charging to a cranking or house battery. Comes complete with 4 6' cords.
Never requires maintenance and is impervious to water and vibration.
Price:$ 549.95 / Each | |
|
| Connect engine alternator to two batteries or battery banks for independant battery charging. Isolates batteries and prevents a higher charged batery from discharging into a lower charged battery. Automatically charges the batteries when the engine is running. Features solid state design, rubber wire caps, marine grade construction, 12 volt operation and one year warranty.
Model 2420A is designed for use with outboard alternators with regulator rectifier.
Price:$ 69.95 / Each | |
| |
The brains of the new Intelligent Choice Charger are evidenced in thecontrol center which is located at the top of the charger. This membrane covered panel is positioned for easy view of all functions and easy access to the user selectable buttons. The control center features easy to read LED Indicators of charge status, user selectable
buttons to tailor the charge for specific battery types (AGM/Flooded or Gel) per output, and warning indicators to alert you before a serious problem. The heart of the electronics system is mounted on an anodized aluminum base to provide efficient heat dissipation and decreased weight. The circuits are coated in epoxy to protect the sensitive electronic components from water or vibration. The charger case is slotted on the sides to provide convection cooling of the anodized aluminum base plate while maintaining an IP65 Water Resistance standard.
Price:$ 109.95 / Each | |
|
The MARINCO On-Board Charger Inlet makes battery charging through an on-board battery charger safer and more convenient. The inlet mounts on the boats exterior and is hard wired directly to the charger. Just open the flip lid cover and plug an extension cord into the inlet to bring charging power to the boats batteries. All of the hatches remain closed and locked throughout the charging cycle, adding convenience and security for the boater.
Price:$ 19.95 / Each | |
| | |
